EverFocus EPN Plus Series Instrukcja Użytkownika Strona 1

EPN Plus

EZN Plus Series 3 3. Installation 3.1 Packing List The main box contains 3 boxes and a small box. Each bo

EZN Plus Series 93 Appendix A. Working in Conjunction with EverFocus’ EKB500 Keyboard You can control multi

EverFocus E

EZN Plus Series 4 3.2 Optional Accessories • EPTZ- PBOX (External power connection box) • Corner mount

EZN Plus Series 5 3.3 Cable Descriptions 1234567RS-485+ (Yellow)RS-485- (Orange)24V ACVideo CableAudio In (

EZN Plus Series 6 3.4 I/O Terminal Block The I/O terminal block, located on the rear panel of the Base Board

EZN Plus Series 7 3.5 Basic Installation for Outdoor Models There are two ways to install the outdoor models

EZN Plus Series 8 3.5.2 Important Note for Installation Before installing, insert a micro SD card into the m

EZN Plus Series 9 3.5.2.2 Inserting a Micro SD Card 1. Unscrew the four screws on the camera main body to r

EZN Plus Series 10 3.5.2.3 Optionally Setting Up the DIP Switch To allow the control device, such as a

EZN Plus Series 11 ON1 2 3 4 5 6 7 8Switch Address1ON1 2 3 4 5 6 7 82ON1 2 3 4 5 6 7 83ON1 2 3 4 5 6 7 84ON1

EZN Plus Series 12 ON1 2 3 4 5 6 7 8Switch Address129ON1 2 3 4 5 6 7 8130ON1 2 3 4 5 6 7 8131ON1 2 3 4 5 6 7

Copyright  2012 EverFocus Electronics Corp. All rights reserved. No part of the contents of this manual may be repro

EZN Plus Series 13 The first, second and the third switches on the left are used to set the communicatio

EZN Plus Series 14 3.5.3 Wall-Mount Installation 1. Replace the desiccant bags inside the top housing. See

EZN Plus Series 15 5. Connect the camera’s cables to the related devices such as a speaker. Feed the cables

EZN Plus Series 16 8. Put on the supplied gloves before pushing upward the main body into the top housing. M

EZN Plus Series 17 3.5.4 Ceiling Mount Installation It is required to use the optional Indoor Recessed Mount

EZN Plus Series 18 4. Place and then screw the camera’s top housing on the top disk of the indoor recessed m

EZN Plus Series 19 7. Put on the supplied gloves before pushing upward the main body into the top housing. M

EZN Plus Series 20 9. Slide the surface ring to the fillister and slightly turn it until it is firmly fixed.

EZN Plus Series 21 4. Accessing the User Interface This section explains how to access the Web interface o

EZN Plus Series 22 5. To change the IP address, double-click the IP Address of the camera. Type a new IP add

i Regulato

EZN Plus Series 23 4.2 Settings for Microsoft Internet Explorer To enable Remove Live View, Firmware Upgrade

EZN Plus Series 24 3. In the Download unsigned ActiveX controls field, select Prompt. In the Include local d

EZN Plus Series 25 4.3 Connecting the Camera to the Network There are three methods to connect the IP camera

EZN Plus Series 26 Direct High-Speed Connection In a Direct High-Speed Connection, the camera connects direct

EZN Plus Series 27 5. Live View Window 1. Press the button to display the "Live View" wind

EZN Plus Series 28 5. Video Stream Select the Video Stream (Stream 1 or Stream 2) that will be displayed i

EZN Plus Series 29 Navigation Mode: Select this to navigate the camera view with your mouse. Move your mouse

EZN Plus Series 30 12. Status Display (info line that can be placed above video box or at bottom of page) Th

EZN Plus Series 31 5.1 PTZ Control Window Click to Zoom In / Zoom OutClick to Focus Near / Focus FarClick to

EZN Plus Series 32 To move the camera in a preconfigured sequence consists of a selection of Patterns and Pr

ii Safety Notice -These limits are designed to provide reasonable protection. This equipment generates, uses and can radiated radio frequency

EZN Plus Series 33 6. Playback You can remotely play back the recordings stored in the on-camera micro SD ca

EZN Plus Series 34 Search by File: Click the Search button to search for all recording files on the on-camera

EZN Plus Series 35 6.2 Setting Up the Playback Function Note that the Playback function will not be active u

EZN Plus Series 36 6.2.2 Testing the Playback Function 1. Once the micro SD card is detected by the system,

EZN Plus Series 37 6.3 Playing Back Using ARV Viewer You can play back the recordings stored in the computer

EZN Plus Series 38 7. Settings Click the Settings button on the Live View Window to enter the settings subme

EZN Plus Series 39 7.1.2 Log Click the Log tab, the following dialog box appears. The sequence number, date,

EZN Plus Series 40 7.2 User Config Each user can set a different configuration for his/her Live page here. T

EZN Plus Series 41 Click Apply to apply the changes or Reset to reset without saving the changes. 【Date/Time

EZN Plus Series 42 7.3 Network This page covers network-related settings, including Network, DDNS, SMTP/FTP,

iii Installation should be performed by qualified service personnel only in accordance with the National Electrical Code or applicable loca

EZN Plus Series 43 IP address: When DHCP is not used, the user needs to manually enter the IP address of the

EZN Plus Series 44 7.3.2 DDNS DDNS (Dynamic Domain Name System) is a service used to map a domain name to th

EZN Plus Series 45 Click Apply to apply the setting changes or Reset to reset without saving the changes. No

EZN Plus Series 46 7.3.3 SMTP / FTP 【Set SMTP Server (email)】This area is for configuring the mail server

EZN Plus Series 47 Sender Address: Input the sender’s e-mail address, so that the receiver can recognize the

EZN Plus Series 48 7.3.4 HTTPS Hypertext Transfer Protocol Secure (HTTPS) is a combination of the Hypertext

EZN Plus Series 49 3. Click the Property button, a pop-up window appears to display the details of the certi

EZN Plus Series 50 3. Click the Property button, a pop-up window appears to display the details of the certi

EZN Plus Series 51 7.3.5 SNMP The default values for SNMP v1/v2/v2c and SNMP v3 are already filled in. Click

EZN Plus Series 52 7.4 Video The settings relating to video such as streaming, camera OSD can be configured

ivContents1. Introduction...

EZN Plus Series 53 【Video Recording Settings】Select the stream you want to configure and then select whether

EZN Plus Series 54 7.4.2 Camera 【Image Settings】 Use the slider to adjust the value for Brightness, Sa

EZN Plus Series 55 Middle and High. Note that when WDR is ON, some parts of the image may appear solarized. T

EZN Plus Series 56 7.4.3 Advanced

 EZNPlusSeries57LensSettings: FocusMode:Selectonefromthethreemodes.YoucanclickthePushbutton

EZN Plus Series 58 Brightness: Set up the brightness value. Flickerless: Select On / Off to enable / disable

EZN Plus Series 59 D-WDR (Digital Wide Dynamic Range): This feature provides clearer images when both of the

EZN Plus Series 60 Day/Night Settings:  Auto: Select to let the camera automatically switch to Night mode (

EZN Plus Series 61 7.4.4 ROI (Region of Interest) The Region of Interest (ROI) function allows users to set

EZN Plus Series 62 7.4.5 Privacy Mask The Privacy Mask can block out sensitive areas from view, covering the

v 7.3.1 Network ... 42 7.

EZN Plus Series 63 1. Click the Program button, the Privacy Masks panel appears. 2. To set up a Privacy Ma

EZN Plus Series 64 7.5 PTZ 7.5.1 PTZ Control You can set up the Preset Position, Auto Pan, Tour and Patter

EZN Plus Series 65 2. Adjust the camera view to a desired position using the direction button. You can selec

EZN Plus Series 66 To set up an Auto Pan Sequence: 1. Click the Program button next to Set Auto Pan, the fol

EZN Plus Series 67 Tour: You can combine up to 16 preconfigured camera positions and patterns into one long s

EZN Plus Series 68 Pattern: You are given 90 seconds to move the camera (via the PTZ buttons) to different po

EZN Plus Series 69 Power Up Func.: Select the mode that the system will revert to when a power failure occurs

EZN Plus Series 70 7.5.2 PTZ OSD / Area You can set up the Preset Position, Auto Pan, Tour and Pattern funct

EZN Plus Series 71 4. To set up the Left / Right positions for the area, use the direction buttons to move t

EZN Plus Series 72 7.6 Audio You can transmit audio to your computer if you have connected an external micro

EZN Plus Series 1

EZN Plus Series 73 7.7 User 7.7.1 User Information The system administrator can create up to ten user accou

EZN Plus Series 74 Guest: The lowest level of access, which only allows the user access to the Live View page

EZN Plus Series 75 7.7.2 IP Address Filter Use this page to specify IP addresses that are not allowed to acc

EZN Plus Series 76 7.8 Event You can set up the Motion Detection event, Tamper Detection event or the Alarm

EZN Plus Series 77 Alarm Input: Select this if you want a reaction trigger coming from any external, connecte

EZN Plus Series 78  Record to SD Card: Click if you want the camera to start recording its video feed (when

EZN Plus Series 79 7.8.2 Motion Detection Use this page to configure up to four areas in which motion will b

EZN Plus Series 80 7.8.3 Tamper Detection Use this page to set the number of seconds that an alarm signal wi

EZN Plus Series 81 7.8.5 Schedule Use this page to configure a schedule for periods during which the camera

EZN Plus Series 82 7.9 System You can set up the system’s time and SD card settings, and to do maintenance a

EZN Plus Series 2 2. Features  Built-in H.264 / MJPEG digital signal output at 4CIF image size at up to

EZN Plus Series 83 7.9.2 Daylight Saving Click Enable Daylight Saving to enable this schedule, and select th

EZN Plus Series 84 7.9.4 Maintenance 【Maintenance Server】 Reboot: Click this button to reboot the unit wit

EZN Plus Series 85 【Save/Load Video Configuration Server】 Save: To make a backup file of the machine’s video

EZN Plus Series 86 7.10 EKB200 You can connect an EKB200, which is EverFocus’ USB keyboard, to the USB port

EZN Plus Series 87  Set Auto Tracking: This function is not available. Press this key to switch On / Off th

EZN Plus Series 88 8. Upgrading Firmware Using IP Utility You can upgrade the Firmware using the IP Utility

EZN Plus Series 89 5. Highlight the camera and then click Upgrade Firmware. A browsing window appears. 6.

EZN Plus Series 90 9. Specifications Model EPN4122 Plus (Outdoor) / EPN4122i Plus (Indoor) EPN4220 Plus (

EZN Plus Series 91 PAN / TILT Control Horizontal Rotation Speed 0.01°/s ~ 360°/s (1-255 grade shift gears) Ma

EZN Plus Series 92 General Power Source 24V AC Power Consumption 30W Max Operating Temperature -40°C ~ +50