EverFocus Flex1.0 Instrukcja Użytkownika Pobierz pdf (Strona 16)

EverFocus Navigation Access Control Management Software

A prompt indicating the completion of the establishment of each datasheet pops up. Click the

“Exit ” button at the bottom of the page to close the page.

1.3.7 Install the COM+ controller component

Click the “install COM+ controller component” button in the main installation window; a window

as shown in the figure below appears:



After the controller component has installed, no other prompt will pop up.

!NOTE: if the user uses a software installation packet to install the software rather than

the software CD, please do not save the installation file on the desktop of Disk C,

otherwise the COM+ controller component will unable to be installed normally.

1.3.8 Install the desktop reader driver

When requiring the use of the desktop card reader of EverFocus, this driver must be installed.

Click the “install desktop reader driver" button in the main installation window, the installation

process is as shown in the figure below:

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 139 140

Brak uwag

EverFocus Flex1.0 Instrukcja Użytkownika Strona 16