EverFocus ENVS1600 2TB Instrukcja Instalacji Pobierz pdf (Strona 14)

ENVS800 / ENVS1600 / ENVS3200 Installation Manual

14 of 115

5.3 Quick Start Setup

This chapter describes the minimum installation steps to install IP-cameras for standard

(continuous) recording.

Note: This quick start setup is based on the premise that all IP cameras in the system are

installed in the same network and IP-address range as the NVR. The default IP -

setting of the NVR is DHCP mode. If there is no DHCP host on the LAN, a static IP

configuration must be assigned using Windows.

1. Register your camera license serial number(s) (Internet connection required; for

alternate methods see Appendix 9 Online License Procedures.)

A. Open “License Manager” Tool. Click CONFIG -> License Manager

B. Select “On line” as Activate type.

C. Input the “SN (Serial number)”, and then click on “Activate” button.

D. Main Console will be restarted if activated successfully.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 114 115

Brak uwag

EverFocus ENVS1600 2TB Instrukcja Instalacji Strona 14